Removing Battery - MacDon M2170NT Operator's Manual

Removing booster cables
1. Disconnect negative (–) booster cable (A) from the engine
of the unit that was boosted.
2. Disconnect the other end of the negative (–) booster cable
from negative (–) battery post (B) of the booster battery.
3. Disconnect the positive (+) booster cable from positive (+)
battery post (C) of the booster battery.
4. Disconnect the other end of the positive (+) booster cable
from positive (+) battery post (D) of the boosted battery.
5. Replace the black and red rubber battery terminal covers.
6. Close the battery cover. For instructions, refer to
Battery Cover, page 374.

Removing Battery

The windrower's batteries may need to be removed for service, storage, or replacement.
CAUTION
Do NOT attempt to service a battery unless you have the proper equipment and training for the task. Have the
windrower's batteries serviced by a MacDon Dealer.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator's seat for any reason.
1. Shut down the engine, and remove the key from the ignition.
2. Open the battery cover. For instructions, refer to
3. Disconnect the battery harness. For instructions, refer to
262171
MAINTENANCE AND SERVICING
Closing
Figure 6.146: Removing Booster Cables
Opening Battery Cover, page
Disconnecting Battery, page
378
B
C
373.
379.
A
D
Revision A