Replacing Led Lights - Deluxe Cab Only - MacDon M2170NT Operator's Manual

13. Attach the electrical connectors to red tail lights (C).
14. Attach headlight bezel assembly (B) to the frame using the
eight retained hex flange bolts (A). Torque the bolts to
2.0–2.7 Nm (18–24 lbf·in).
Replacing LED Lights – Deluxe Cab Only
The deluxe cab is equipped with several LED lights. If they burn out or are damaged, the entire lamp assembly will need to
be replaced as the bulbs cannot be replaced on their own.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator's seat for any reason.
The deluxe cab is equipped with the following LED lights:
• Four LED field lights (A)
• Two LED stubble lights (B)
• Two LED rear work lights (C)
NOTE:
For replacement parts, refer to the windrower parts catalog or contact your MacDon Dealer. To replace the LED lamp
assembly, proceed to Step
262171
MAINTENANCE AND SERVICING
1, page 406.
A A
C
Figure 6.197: Headlight Bezel Assembly
405
A A
C
A
B
A
Revision A