MacDon M2170NT Operator's Manual page 168

ATTACHING HEADERS TO AND DETACHING HEADERS FROM WINDROWER
15. Approach platform (A) on the left side of the windrower.
Ensure that the cab door is closed.
16. Push latch (B) and pull platform (A) toward the walking
beam until it stops and the latch engages.
17. Push lock button (A) and pull handle (B) to disengage
multicoupler (C). Disconnect the hydraulics from the rear
knife/reel drive receptacle.
NOTE:
Firmly hold handle (B) when disconnecting multicoupler (C).
Pressure may cause the handle to kick back with force.
18. Route the knife/reel drive hose bundle back to storage
position (D) on the hydraulic hose management system.
19. Remove any debris that may have accumulated on the
receptacle.
20. Close cover (E).
21. Push lock button (B), and pull handle (C) to disengage
multicoupler (A). Disconnect the hydraulics from the
windrower draper drive/reel lift receptacle.
22. Disconnect electrical connector (E).
23. Remove any debris that may have accumulated on the
receptacle.
24. Close cover (D).
262171
Figure 4.76: Left Platform
Figure 4.77: Knife/Reel Drive Multicoupler
E
Figure 4.78: Draper/Reel Multicoupler
148
A
D
C
E
A
B
D
B
1015479
B
A
C
Revision A