Table of Contents
Advertisement
ATTACHING HEADERS TO AND DETACHING HEADERS FROM WINDROWER
17. Proceed as follows:
• If the header supports are installed on the windrower:
Install pin (B) through the header leg, engaging the
header support in the lift linkage. Secure the pin with
ring (A).
• If the header supports are installed in the header:
Secure windrower lift linkage (C) to header supports (D)
using clevis pin (E) and hairpin (F).
NOTE:
To ensure that the pin doesn't snag the windrow, install
the clevis pin on the outboard side of the draper header
support.
Repeat this step on the other header leg.
18. Disengage the safety props on both lift cylinders as follows:
a.
Turn lever (A) away from the header to raise the safety
prop until the lever locks into the vertical position.
b. Repeat the previous step for the opposite cylinder.
NOTE:
If the safety prop will NOT disengage, raise the header to
release the prop.
262171
B
D
Figure 4.52: Windrower Lift Linkage and Header Leg
Figure 4.53: Safety Prop Lever
137
A
F
E
A
C
Revision A
Advertisement
Table of Contents
Troubleshooting
