MacDon M2170NT Operator's Manual page 311

1. Shut down the engine, and remove the key from the
ignition.
2. Locate latch (B) beneath the platform.
3. Adjust the latch position by loosening bolts (A) and moving
latch (B).
4. Retighten bolts (A) and close the platform.
5. Rubber bumper (B) at the cab end of the platform should
measure 52–60 mm (2–2 3/8 in.) when properly
compressed against the frame. The platform should also sit
firmly against front guide (A).
NOTE:
The top plate of the platform has been removed for clarity.
6. If adjustment is required, loosen two bolts (C) and slide the
support as required.
7. Tighten bolts (C) to 39.5 Nm (29.1 lbf·ft).
8. To adjust the horizontal position of the platform, loosen
bolts (A) and adjust bolt (B).
9. Tighten bolts (A) to 68.5 Nm (50.5 lbf·ft).
10. Use bolts (C) to adjust the platform angle. Tighten bolts (C)
to 68.5 Nm (50.5 lbf·ft) after adjustment is complete.
262171
MAINTENANCE AND SERVICING
Figure 6.10: Left Platform
Figure 6.11: Left Platform
Figure 6.12: Left Platform
291
B
B
A
A
C C
A
C
B
Revision A