8.4 Header Drive Troubleshooting
Refer to the table provided below if you encounter problems with the header drive while operating the windrower.
Problem
Symptom: Header drive is not engaging.
OPERATOR PRESENCE switch not
closed or faulty
OPERATOR PRESENCE switch not
closed or faulty
Appropriate solenoid not being
energized by activating switch
Couplers not connected
Faulty pump or flow controls
Control solenoids disconnected
Header ID not detected
Symptom: Header drive lacks power.
Relief valve setting too low
Header drive overload
Symptom: Warning alarm sounds.
Header drive overload
Relief valve setting too low
262171
TROUBLESHOOTING
Solution
Occupy operator's seat or replace
switch. Contact your Dealer.
Occupy operator's seat or replace
switch. Contact your Dealer.
Contact Dealer.
Contact Dealer.
Contact Dealer.
Contact Dealer.
Attach header or check wiring.
Contact your Dealer.
Contact Dealer.
Reduce ground speed.
Reduce ground speed.
Contact Dealer.
441
Section
Contact Dealer
Contact Dealer
—
—
—
—
Contact Dealer
—
—
—
—
Revision A