ATTACHING HEADERS TO AND DETACHING HEADERS FROM WINDROWER
2. Before beginning this procedure, make sure draper header
supports (A) are installed on both windrower lift linkages.
For instructions on installing the header supports onto the
windrower, refer to
4.3.1 Attaching Draper Header
Supports, page
151.
3. Extend the windrower wheels from narrow transport into
field mode. For instructions, refer to
Field Mode, page
224.
4. Rotate left signal light placard (A) to the up (vertical)
position before connecting the windrower to a header.
5. Remove hairpin (A) from pin (B), and remove pin (B) from
the header leg. Repeat this step on the opposite header leg.
6. Start the engine.
262171
Extending Wheels –
153
Figure 4.88: Header Supports Installed
Figure 4.89: Left Signal Light Placard
A
B
Figure 4.90: Header Leg
A
A
Revision A