5.4.5 Setting Header Height
The header height can be adjusted using the ground speed lever (GSL).
Raise or lower the header with the HEADER UP (A) or HEADER
DOWN (B) switches on the GSL.
HEADER HEIGHT (A) is always displayed on the HarvestTouch
Display screen.
NOTE:
When setting the cutting height for draper headers, the fore-aft,
reel height, and header height settings are limited as follows to
prevent the reel from contacting the cab roof:
• If you increase header height (A) to greater than 7.0 while
reel height setting (B) is greater than 7.0, and reel fore-aft
setting (C) is greater than 5.0, the reel fore-aft will
automatically adjust forward to 5.0 or less to avoid
contacting the cab roof.
• After the reel fore-aft automatically moves, you will then
have to manually adjust the fore-aft.
• For instructions about operating the reel fore-aft, refer to
5.5.3 Adjusting Reel Fore-Aft Position, page
262171
OPERATION
Figure 5.112: GSL
™
Figure 5.113: HarvestTouch
Header Shown
251.
247
B
B
A
Display – Draper
™
A
C
Revision A