Table of Contents
Advertisement
Configuring Infiniium Windows XP Scopes
Configuring Windows XP Infiniium etworking for non-DHCP etwork
Configuring Windows XP Infiniium etworking for
non-DHCP etwork
Complete the following procedure to configure your Windows XP Infiniium scope
for networking via a non-DHCP (Dynamic Host Configuration Protocol) network.
To configure Windows XP Infiniium networking for a non-DHCP
network:
1. You will need an IP Address, Gateway Address and a Subnet Mask from your
Network Administrator.
2. On your Infiniium, quit the Scope application if it is running.
3. Open the Control Panel (Start > Control Panel). Open etwork
Connections. (If you are in Category view, click Network and Internet
Connections and then select Network Connections.)
4. Click Local Area Connection and then Properties to display the Local Area
Connection Properties dialog box.
5. Select Internet Protocol (TCP/IP) on the connection list and click Properties
to display the Internet Protocol (TCP/IP) Properties dialog box.
6. Select Use the following IP address and enter the IP Address, Subnet mask,
and Default gateway address provided by your Network Administrator.
7. Click OK in the Internet Protocol (TCP/IP) Properties dialog box.
8. Click OK in the Local Area Connection Properties dialog box. If Windows
prompts you to reboot your Infiniium, click Yes. If not, close all open dialog
boxes.
9. After the Infiniium reboots, the instrument is ready for LAN control over the
LAN interface. Go to
connection" on page
114
"Configuring PC Agilent IO Config for LAN
119.
Chapter 7
Advertisement
Table of Contents
Troubleshooting
