Table of Contents
Advertisement
RF Vector Network Analyzer
N9923AN
Maintenance
To prevent electrical shock, disconnect the analyzer from the mains
WARNING
source before cleaning. Use a dry cloth or one slightly dampened
with water to clean the external case parts. Do not attempt to clean
internally.
Physical Maintenance
Clean the analyzer case using a dry or slightly damp cloth only.
Electrical Maintenance
Refer to
"Contacting Agilent" on page 2-6
Analyzer Options
Below is a list of options available for the FieldFox N9923AN. Additional options may be
added as product features are enhanced. Go to
information on currently available upgrade options.
This manual applies to both the N9923A and the N9923AN models. Both models are
physically and functionally identical. The base model for N9923A includes only option 104.
The base model for N9923AN includes option 104, 305, and 308.
Frequency Range Options
Option 104, 2 MHz to 4 GHz Frequency Range
This option allows you to make measurements in the 2 MHz to 4 GHz frequency range.
Option 106, 2 MHz to 6 GHz Frequency Range
This option allows you to make measurements in the 2 MHz to 6 GHz frequency range.
Network Analyzer (NA) Options
Option 122, Full 2-Port S-Parameters
The standard vector network analyzer allows you to make S11 and S21 measurements.
Option 122 allows you to make S11, S12, S21, S22, A, B, R1, and R2 measurements.
Option 112, QuickCal
This option provides a calibration that is performed automatically using calibration
standards that are built-in to the N9923AN. Calibration standards are automatically
switched in as needed. QuickCal is ideal for making quick DTF and cable loss
measurements without taking the time to perform a full O,S,L Cal.
Service Guide N9923-90005
and to
Chapter 3, "Tests and Adjustments."
www.agilent.com/find/fieldfox2
General Product Information
Maintenance
for
2-3
Advertisement
Table of Contents
Troubleshooting
