Introduction; When Using A Switching Hub With Cc-Link Ie Tsn; Compliance With Emc And Low Voltage Directives - Mitsubishi Electric MELSEC iQ-R Series User Manual

INTRODUCTION

Thank you for purchasing the Mitsubishi Electric MELSEC iQ-R series programmable controllers.
This manual describes the system configuration, procedures, wiring, functions, programming, and troubleshooting of the
relevant product listed below.
Before using this product, please read this manual and the relevant manuals carefully and develop familiarity with the
functions and performance of the MELSEC iQ-R series programmable controller to handle the product correctly.
When applying the program examples provided in this manual to an actual system, ensure the applicability and confirm that it
will not cause system control problems.
Note that the menu names and operating procedures may differ depending on an operating system in use and its version.
When reading this manual, replace the names and procedures with the applicable ones as necessary.
Please make sure that the end users read this manual.
Relevant product
RJ71GN11-EIP
Unless otherwise specified, the buffer memory addresses used for P1/P2 common in this manual are for when
the P1 connecter is used.
Check the corresponding buffer memory addresses in the list and use the correct addresses. ( Page 460
List of buffer memory addresses (common information))
WHEN USING A SWITCHING HUB WITH CC-Link IE
TSN
A dedicated TSN hub may be required depending on parameter settings or the network topology used to connect modules on
CC-Link IE TSN.
Read the following carefully.
Page 26 CC-Link IE TSN SYSTEM CONFIGURATION
Page 72 Switching hub (when the system configured with CC-Link IE TSN)
COMPLIANCE WITH EMC AND LOW VOLTAGE
DIRECTIVES
Method of ensuring compliance
To ensure that Mitsubishi Electric programmable controllers maintain the EMC and Low Voltage Directives or other
regulations when incorporated into other machinery or equipment, certain measures may be necessary. Please refer to one of
the following manuals.
• MELSEC iQ-R Module Configuration Manual(SH-081262ENG)
• Safety Guidelines (IB-0800525)
Certification marks on the side of the programmable controller indicate compliance with the relevant regulations.
Additional measures
To ensure that this product maintains the EMC and Low Voltage Directives or other regulations, please refer to the following.
• MELSEC iQ-R Module Configuration Manual(SH-081262ENG)
• Safety Guidelines (IB-0800525)
11