Introduction - Mitsubishi Electric MELSEC iQ-F FX5 Series User Manual

INTRODUCTION

Thank you for purchasing the Mitsubishi Electric MELSEC iQ-F series programmable controllers.
This manual contains text, diagrams and explanations which will guide the reader in the correct installation, safe use and
operation of the Motion module of MELSEC iQ-F series and should be read and understood before attempting to install or use
the module.
Always forward it to the end user.
Relevant products
FX5-40SSC-G, FX5-80SSC-G
Regarding use of this product
• This product has been manufactured as a general-purpose part for general industries, and has not been designed or
manufactured to be incorporated in a device or system used in purposes related to human life.
• Before using the product for special purposes such as nuclear power, electric power, aerospace, medicine or passenger
movement vehicles, consult Mitsubishi Electric.
• This product has been manufactured under strict quality control. However when installing the product where major
accidents or losses could occur if the product fails, install appropriate backup or failsafe functions in the system.
Note
• If in doubt at any stage during the installation of the product, always consult a professional electrical engineer who is
qualified and trained in the local and national standards. If in doubt about the operation or use, please consult the nearest
Mitsubishi Electric representative.
• Since the examples indicated by this manual, technical bulletin, catalog, etc. are used as a reference, please use it after
confirming the function and safety of the equipment and system. Mitsubishi Electric will accept no responsibility for actual
use of the product based on these illustrative examples.
• This manual content, specification etc. may be changed, without a notice, for improvement.
• The information in this manual has been carefully checked and is believed to be accurate; however, if you notice a doubtful
point, an error, etc., please consult your local Mitsubishi Electric representative. When doing so, please provide the manual
number given at the end of this manual.
• The term "Slave station" and "Authentication Class" have been replaced with "Device station" and "CC-Link IE TSN Class"
in accordance with CC-Link Partner Association's policy. However, the terms have not been replaced yet in some areas in
the engineering tool, and there may be differences between some window images of the engineering tool and the
corresponding description in this manual. In that case, read the terms in the engineering tool's windows as follows.
Network
CC-Link IE TSN
10
Engineering tool
Slave station
Authentication Class
Replacement term
Device station
CC-Link IE TSN Class