5.
Set the refresh settings as follows.
[Navigation window] [Parameter] [Module Information] [RJ71GN11-T2] [Basic Settings] [Refresh Settings]
[Detailed Setting]
6.
Click the [Apply] button.
7.
Write the set parameters to the CPU module on the local station. Then, reset the CPU module or power off and on the
system.
[Online] [Write to PLC]
In this example, default values are used for parameters that are not shown above. For the parameters, refer to
the following.
MELSEC iQ-R CC-Link IE TSN User's Manual (Application)
Settings in the local station (station No.2)
1.
Set the CPU module and add the module labels of the CPU module. The setting method of the CPU module and addition
method of the module label are the same as those of the master station. ( Page 219 Setting in the master station)
2.
Set a local station (RJ71GN11-EIP) as follows.
[Navigation window] [Parameter] [Module Information] Right-click [Add New Module]
3.
Add a module label of the local station. The addition method of the module label is the same as that of the master station.
( Page 219 Setting in the master station)
11.2 Communication Example of the Master Station and Local Stations
11 PROGRAMMING
223
11