Mitsubishi Electric MELSEC iQ-R Series User Manual page 88

Communication Speed
Set the communication speed.
Item
Communication Speed
For details on the connection of modules or devices based on the communication speed setting, refer to the following.
Page 26 CC-Link IE TSN SYSTEM CONFIGURATION
Supplementary Cyclic Settings
Set the station-based block data assurance and I/O maintenance settings.
Item
Station-based Block Data Assurance
I/O Maintenance
Settings
Transient Transmission Group No.
Set the transient transmission group number.
Item
Transient Transmission Group No.
Communication Mode
Set the communication mode.
Item
Communication Mode
Parameter Name
Set a name for the module parameter if desired.
Item
Parameter Name
8 PARAMETER SETTINGS
86
8.1 Parameter Settings for CC-Link IE TSN
Description
Select the communication speed.
Output Hold/Clear Setting during
CPU STOP
Data Link Error Station Setting
Output Mode upon CPU Error
Description
Set the group number to perform transient transmission using group specification.
Description
Set the communication mode.
Description
Set a name for the module parameter if desired.
Description
Select whether to ensure a data integrity of the data blocks being
refreshed between the CPU module and the CC-Link IE TSN Plus
module. ( Page 158 Cyclic data assurance)
Select whether to hold or clear output when the status of the CPU
module changes from RUN to STOP. Set it on the sending side.
( Page 168 I/O maintenance settings)
Select whether to clear or hold input from a disconnected station.
Set it on the receiving side. ( Page 168 I/O maintenance
settings)
Select whether to hold or clear output when a stop error occurs in
the CPU module. Set it on the sending side. ( Page 168 I/O
maintenance settings)
Setting range
• 1Gbps
• 100Mbps
(Default: 1Gbps)
Setting range
• Enable
• Disable
(Default: Enable)
• Hold
• Clear
(Default: Hold)
• Clear
• Hold
(Default: Clear)
• Clear
• Hold
(Default: Clear)
Setting range
0 to 32 (0: No group
specification)
(Default: 0)
Setting range
• Unicast
• Multicast
(Default: Unicast)
Setting range
Up to 8 one-byte or two-byte
characters
(Default: empty)