6.
Set the items in "Basic Settings" as follows.
[Navigation window] [Parameter] [Module Information] [RJ71GN11-EIP(T+E)] [Port1 Module Parameter (CC-
Link IE TSN)] [Basic Settings]
In this manual, "Authentication Class" is described as "CC-Link IE TSN Class".
7.
Set the socket communications network configuration as follows.
[Navigation window] [Parameter] [Module Information] [RJ71GN11-EIP(T+E)] [Port1 Module Parameter (CC-
Link IE TSN)] [Basic Settings] [External Device Configuration]
8.
Click the [Close with Reflecting the Setting] button to close the "Ethernet Configuration" window.
9.
Click the [Apply] button.
10.
Write the set parameters to the CPU module on the master station. Then, reset the CPU module or power off and on the
system.
[Online] [Write to PLC]
In this example, default values are used for parameters that are not shown above. For the parameters, refer to
the following.
Page 73 Parameter Settings for CC-Link IE TSN
11 PROGRAMMING
11.4 Example of Socket Communications
11
247