EtherNet/IP communication in process (X10)
This signal turns on or off depending on the start status of the EtherNet/IP communications. It is recommended to use this
signal for interlocking the program.
• On: EtherNet/IP communication is starting.
• Off: EtherNet/IP communication is stopped.
For the timing chart, refer to the following.
Page 488 EtherNet/IP communication start request (Un\G7340096)
PING test completion (X12)
This signal turns on or off depending on the execution status of the PING test.
• On: The PING test has completed.
• Off: The PING test has not completed.
For the timing chart, refer to the following.
Page 455 PING test execution request (Y12)
Communication Ready (X1F)
This signal turns on when the communication preparation for the CC-Link IE TSN Plus module completes.
• On: Communication preparation has completed.
• Off: Communication preparation is in progress.
APPX
454
Appendix 2 I/O Signals