Chapter 2 Cc-Link Ie Tsn System Configuration - Mitsubishi Electric MELSEC iQ-R Series User Manual

2
CC-Link IE TSN SYSTEM CONFIGURATION
CC-Link IE TSN is configured using Ethernet cables. ( Page 71 Ethernet cable)
(1)
(1) CC-Link IE TSN Plus module
(2) Inverter device
(3) Remote I/O module
(4) Ethernet device (such as a vision sensor)
Precautions
• When CC-Link IE TSN is used with the CC-Link IE TSN Plus module, only P1 can be connected. (P2 cannot be
connected.) Therefore, connect the CC-Link IE TSN Plus module to the end of the system configuration.
• A dedicated TSN hub may be required depending on parameter settings or the network topology used to connect modules
on CC-Link IE TSN.
System configuration list
The following is a list of system configurations.
Structure
Structure of CC-Link IE TSN Class B devices and Ethernet devices
Structure of CC-Link IE TSN Class B/A devices and Ethernet devices
Structure of CC-Link IE TSN and CC-Link IE Field Network
Structure When CC-Link IE TSN Communication Software is used
Unicast mode and multicast mode
Cyclic transmission differs depending on the communication mode set by the module parameter of the master station. The
communication modes are as follows.
• Unicast mode
• Multicast mode
For details, refer to the following.
Page 142 Cyclic Transmission
2 CC-Link IE TSN SYSTEM CONFIGURATION
26
(2) (3) (4)
Reference
Page 28 Structure of CC-Link IE TSN Class B Devices and Ethernet Devices
Page 38 Structure of CC-Link IE TSN Class B/A Devices and Ethernet Devices
Page 53 Structure of CC-Link IE TSN and CC-Link IE Field Network
Page 54 Structure When CC-Link IE TSN Communication Software Is Used