Mitsubishi Electric MELSEC iQ-R Series User Manual page 90

Security
Set the security measures for access to the Ethernet device.
Item
IP Filter IP Filter
Settings
IP Filter Settings
■IP Filter Settings
Up to 32 IP addresses can be set as an IP address to be allowed or denied by the IP filter.
Range specification and specification of the IP addresses to be excluded from the set range as a single setting are possible.
Item
Access from IP address below
Range Setting
IP Address
IP Address Excluded from Range
Interlink Transmission Settings
Set link device ranges when cyclic data are transferred from a station in the own network to a station in a different network.
■Modules that can support interlink transmission
The following modules support interlink transmission.
• RJ71GN11-EIP (master station)
• RJ71GN11-T2 (master station)
• CC-Link IE Controller Network-equipped module (control station, normal station)
• CC-Link IE Field Network-equipped module (master station and submaster station)
• RJ71LP21-25 (control station and normal station)
■Setting method
The procedure for the interlink transmission settings is shown below.
1.
Select combination of modules in the "Transfer Source Module" and "Transfer Destination Module" boxes and enter
setting values.
8 PARAMETER SETTINGS
88
8.1 Parameter Settings for CC-Link IE TSN
Description
Set whether to use the IP filter.
Set the IP addresses to be allowed or denied.
Description
Select whether to allow or deny the access from the specified IP addresses.
Select this item when specifying the IP addresses by range.
Set the IP addresses to be allowed or denied.
When selecting "Range Setting", enter the start IP address (left field) and end IP address
(right field) of the range.
When selecting "Range Setting", set the IP address to be excluded from the set range.
Up to 32 IP addresses can be set.
Setting range
• Disable
• Enable
(Default: Disable)

Setting range
• Allow
• Deny
(Default: Allow)
(Default: Clear)
0.0.0.1 to
223.255.255.254
(Default: empty)
0.0.0.1 to
223.255.255.254
(Default: empty)