Mitsubishi Electric MELSEC iQ-R Series User Manual page 380

Item
Network Total Slave Stations
Status (Parameter)
Total Slave Stations
(Connected)
Communication Cycle
Interval Setting value
Number of Station
Errors Detected
Communication Mode
Change IP Address
Display
Network map
Data Unlinked
Selected Station Communication Status
Monitor
Operation Test [Communication Test]
button
Information [Station Information
Confirmation/ List] button
Setting
Selected [Remote Operation]
Station button
Operation
17 CHECKING THE NETWORK STATUS
378
17.1 Checking the Status of CC-Link IE TSN
Description
Displays the total number of slave stations set in "Network Configuration Settings" under "Basic Settings".
Stores the total number of slave stations (number of slave stations) that are actually connected by data link in the
CC-Link IE TSN.
The communication cycle interval set in "Communication Period Setting" under "Basic Settings" of the master station
is displayed. (s unit)
Indicates the number of error stations in the displayed network.
Indicates the communication mode set in "Communication Mode" under "Application Settings" of the master station.
Allows to select from "DEC" or "HEX" for IP address display on the selected communication status monitor and
network map. (Default: Decimal)
Indicates the CC-Link IE TSN structure and the status of each station. ( Page 379 Network map)
If the status of each station is not displayed, check whether there are any overlaps of master stations.
Displays a disconnected station that has been set in "Network Configuration Settings" under "Basic Settings" but has
not yet performed data link. Reserved stations or error invalid stations are also included.
However, even if a disconnected station had performed data link, disconnected stations in the following cases are
displayed in this area.
• A station that was reconnected to a network after disconnecting/inserting the cable or powering off and on the
system, and remains disconnected
• A disconnected station with the station icon deleted in the network map by clicking the [Update] button
Displays the station number on the station icon.
The "Other Modules" icon indicates a station that has not yet performed data link.
Icons other than the "Other Modules" icon indicate stations that had performed data link before disconnection.
For details on the displayed icon, click the [Legend] button.
Status of the station selected in "Network Status" is displayed. ( Page 381 Selected Station Communication
Status Monitor)
Performs a communication test. ( Page 382 Communication Test)
Displays information of the slave stations which are performing data link in list form. ( Page 383 Station
Information List)
Performs remote operation (such as RUN, STOP, or RESET operations) to the CPU module. ( Page 384
Remote Operation)