16.
Set the parameter for the Class1 tag communications in "Connection Detailed Setting".
17.
Click the [Apply] button.
18.
Click the [OK] button to close the connection settings.
19.
Select [Close with Reflecting the Setting] and close the "EtherNet/IP Configuration" window.
20.
Write the set parameters to the originator-side CPU module. Then reset the CPU module or power off and on the system.
[Online] [Write to PLC]
In this example, default values are used for parameters that are not shown above. For the parameters, refer to
the following.
Page 112 EtherNet/IP Parameter Settings
13.2 Class1 Communications Communication Example
13 PROGRAMMING
303
13