7.
Select "Connection (Adapter Instance Communications)" in "Select Connection to be Added:" and click the [OK] button.
8.
Set the parameter for the Class1 instance communications in "Detailed Connection Settings".
9.
Click the [Apply] button.
10.
Click the [OK] button to close the connection settings.
11.
Select [Close with Reflecting the Setting] and close the "EtherNet/IP Configuration" window.
12.
Write the set parameters to the target 1-side CPU module. Then reset the CPU module or power off and on the system.
[Online] [Write to PLC]
In this example, default values are used for parameters that are not shown above. For the parameters, refer to
the following.
Page 112 EtherNet/IP Parameter Settings
13.2 Class1 Communications Communication Example
13 PROGRAMMING
305
13