Mitsubishi Electric MELSEC iQ-R Series User Manual page 333

16.
Write the set parameters to the client-side CPU module. Then reset the CPU module or power off and on the system.
[Online]  [Write to PLC]
In this example, default values are used for parameters that are not shown above. For the parameters, refer to
the following.
Page 112 EtherNet/IP Parameter Settings
Setting the CC-Link IE TSN Plus module (server)
Connect the engineering tool to the server-side CPU module and set the parameters.
1.
Set the CPU module and add the CC-Link IE TSN Plus module. The setting method of the CPU module and addition
method of the CC-Link IE TSN Plus module are the same as those of the CC-Link IE TSN Plus module (client). (
Page 328 Setting the CC-Link IE TSN Plus module (client))
2.
Set the items in "Basic Settings" as follows.
[Navigation window]  [Parameter]  [Module Information]  [RJ71GN11-EIP(T+E)]  [Port2 Module Parameter
(EtherNet/IP)]  [Basic Settings]
3.
Set the items in "Application Settings" as follows.
[Navigation window]  [Parameter]  [Module Information]  [RJ71GN11-EIP(T+E)]  [Port2 Module Parameter
(EtherNet/IP)]  [Application Settings]
4.
Click the [Apply] button.
5.
Write the set parameters to the server-side CPU module. Then reset the CPU module or power off and on the system.
[Online]  [Write to PLC]
In this example, default values are used for parameters that are not shown above. For the parameters, refer to
the following.
Page 112 EtherNet/IP Parameter Settings
13.5 Class3 Message Communications Communication Example
13 PROGRAMMING
331
13