9.
From "Module List", add "RJ71GN11-EIP(T+E)" to the list of EtherNet/IP devices and then configure the settings as
follows.
If "RJ71GN11-EIP(T+E)" is not shown in the "Module List", it is necessary to add the EDS file.
For adding the EDS file, refer to the following.
Page 129 Adding the EDS file
10.
Double-click "<Detailed Setting>" in the "Connection Setting" column and set the connections for Target 1 and Target 2.
11.
Select the target 1 under "Scanner" in "Connection List" and click the [Add Connection] button.
12.
Select "Input Only (Class1 Instance)" in "Select Connection to be Added:" and click the [OK] button.
13.2 Class1 Communications Communication Example
13 PROGRAMMING
301
13