Mitsubishi Electric MELSEC iQ-R Series User Manual page 363

Attribute Access
(: Available, :
ID
Not available)
Get Set
*2
5  
 
6
7  
 
8
9  
 
11
Name
Media Alignment Errors
Counters
FCS Errors
Single Collisions
Multiple Collisions
SQE Test Errors
Deferred Transmissions
Late Collisions
Excessive Collisions
MAC Transmit Errors
Carrier Sense Errors
Frame Too Long
MAC Receive Errors
Interface Control Bits
Control
Forced Interface Speed
Interface Type
Interface State
Admin State
Interface Capability Bits
Capability
Speed/ Speed/Duplex Array
Duplex Count
Options
Speed/
Duplex
Array
Data Description
type
UDINT Number of receive frames with
lengths that are not octet integers
UDINT Number of receive frames that do
not pass the FCS check
UDINT Number of frames transmitted
successfully with only one
collision
UDINT Number of frames transmitted
successfully with two or more
collisions
UDINT Number of times SQE test error
messages were created
UDINT Number of frames for which the
first transmission test was
delayed due to the medium being
busy
UDINT Number of collisions detected in
packet transmission after 512 bit
time or later in packet
transmission
UDINT Number of failed frames in
transmission due to excessive
collisions
UDINT Number of frames that failed to
be transmitted due to internal
MAC sublayer transmission
errors
UDINT Number of times the carrier
sense condition was lost or was
not asserted during attempts to
transmit frames
UDINT Number of receive frames that
exceeded the maximum
allowable frame size
UDINT Number of frames that failed to
be received through interface due
to internal MAC sublayer
receiving errors
WORD Interface control bits
UINT Forced interface operation speed
USINT Interface type
USINT Current interface status
USINT Current administration status
DWORD Interface function other than
Speed/Duplex
USINT Number of Speed/Duplex arrays
Interface UINT Speed to force the interface to
Speed operate at
Interface USINT Duplex mode of the interface
Duplex
Mode
14 MESSAGE COMMUNICATION SUPPORT COMMANDS
Setting value
(Set)/stored
value (Get)
Value on the left
Value on the left
Value on the left
Value on the left
0
Value on the left
Value on the left
14
Value on the left
Value on the left
Value on the left
Value on the left
Value on the left
0001H
0000H
02H
01H
01H
00000006H
00H

*1

361
14.5 Ethernet Link