Mitsubishi Electric MELSEC iQ-R Series User Manual page 270

Master/local module
Hide thumbs Also See for MELSEC iQ-R Series:
Table of Contents

Advertisement

Connection settings
The following settings are required when performing instance communication using the CC-Link IE TSN Plus module as the
originator.
• Check the instance ID set for the target
• Use "EtherNet/IP Configuration" to configure the scanner settings for the CC-Link IE TSN Plus module based on the
instance ID set for the target
The instance IDs when using the CC-Link IE TSN Plus module as a target are shown as follows.
I/O
(T: Target, O: Originator)
Input (T->O)
Output (O->T)
The following settings are required when performing instance communication using the CC-Link IE TSN Plus module as the
target.
• Use "EtherNet/IP Configuration" to configure the adapter settings for the CC-Link IE TSN Plus module
• Set the originator device to perform communication with the instance ID that matches the adapter settings
*1 For the setting and checking method, refer to the manual for the external device. Depending on the device used, a fixed value may be
specified in the EDS file and it may not be described in the manual.
*2 For the CC-Link IE TSN Plus module setting method, refer to the following.
Page 117 "EtherNet/IP Configuration" window
Precautions
To start EtherNet/IP communications by setting a value other than 0 for 'EtherNet/IP communication start request
(Un\G7340096)', set all 'Class1 cyclic pause specification' (Un\G7735808 to Un\G7735823) to 0.
When 'Class1 cyclic pause specification' (Un\G7735808 to Un\G7735823) is not all set to 0, EtherNet/IP communications will
not start even if a value other than 0 is set for 'EtherNet/IP communication start request' (Un\G7340096).
In this case, 2 (cannot start) is stored for 'EtherNet/IP communication start status' (Un\G7340097).
12 FUNCTIONS
268
12.2 Cyclic Transmission Function
*1
.
*2
.
Connection No.
(Specified when setting the CC-Link IE
TSN Plus module adapter.)
1
2
255
256
Instance ID
(Automatically generated according to
the connection No.)
768
769
767 + Connection No.
1022
1023
198 (fixed value)
*2
.
*1*2
.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Melsec iq-r cc-link ie tsn plus

Table of Contents