Show System Hardware; Show System Output Details - Enterasys SecureStack C2 C2G170-24 Configuration Manual

show system hardware

The following table provides an explanation of the command output.
Table 3-4 show system Output Details
Output
System contact
System location
System name
Switch x
PS1-Status
PS2-Status
Fanx-Status
Temp-Alarm
Thermal Threshold
Temp alarm max
threshold
Temp alarm trap
Temp alarm syslog
Uptime d,h:m:s
Logout
show system hardware
Use this command to display the system's hardware configuration.
Syntax
show system hardware
Parameters
None.
Defaults
None.
3-14 Basic Configuration
What It Displays...
Contact person for the system. Default of a blank string can be changed with the
set system contact command
Where the system is located. Default of a blank string can be changed with the
set system location command
Name identifying the system. Default of a blank string can be changed with the
set system name command
Indicates the switch position in the stack. When multiple switches are in a stack,
information for each switch is displayed.
Operational status for the primary power supply.
Operational status for the secondary power supply, if installed.
Operational status of the fan(s).
Indicates status of temperature alarm — on, off. The status will show NA (not
available) on switches that do not support this functionality.
Percentage of thermal threshold reached. The status will show NA (not available)
on switches that do not support this functionality.
The temperature alarm threshold expressed as a percentage of the maximum
rated. The default value is 100%.
Indicates whether the sending of temperature alarm traps is enabled or disabled.
The default is disabled.
Indicates whether temperature alarm syslog messages are enabled or disabled.
The default is disabled.
System uptime.
Time an idle console or Telnet CLI session will remain connected before timing
out. Default of 5 minutes can be changed with the set logout command
logout" on page 3-29).
("set system contact" on page 3-27).
("set system location" on page 3-26).
("set system name" on page 3-26).
("set