Assigning Ports To Policy Profiles; Purpose; Commands; Set Policy Port - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Assigning Ports to Policy Profiles

Purpose

To assign and unassign ports to policy profiles.

Commands

For information about...

set policy port

clear policy port
set policy port
Use this command to assign ports to a policy profile.
Syntax
set policy port port-string profile-index
Parameters
port‐string
profile‐index
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to allow Gigabit Ethernet ports 5 through 15 in slot 1 to transmit frames
according to policy profile 1:
C2(su)->set policy port ge.1.5-15 1
Note: The C2 switch supports up to three user policies per port.
Specifies the port(s) to add to the policy profile. For a detailed description
of possible port‐string values, refer to "Port String Syntax Used in the CLI"
on page 7‐2.
Specifies the ID of the policy profile (role) to which the port(s) will be
added. This value must match the profile‐index value assigned using the
set policy profile command ("set policy profile" on page 11‐3) in order
for a policy profile to be active on the specified port.
Assigning Ports to Policy Profiles
Refer to page...
11-15
11-16
SecureStack C2 Configuration Guide 11-15