Set Sntp Client; Clear Sntp Client - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Table 14-7 show sntp Output Details (Continued)
Output Field
Last SNTP Status
SNTP-Server
Precedence
Status

set sntp client

Use this command to set the SNTP operation mode.
Syntax
set sntp client {broadcast | unicast | disable}
Parameters
broadcast
unicast
disable
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to enable SNTP in broadcast mode:
C2(su)->set sntp client broadcast

clear sntp client

Use this command to clear the SNTP client's operational mode.
Syntax
clear sntp client
Parameters
None.
Defaults
None.
What It Displays...
Whether or not broadcast reception or unicast transmission and reception was
successful.
IP address(es) of SNTP server(s).
Precedence level of SNTP server in relation to its peers. Highest precedence is 1
and lowest is 10. Default of 1 can be reset using the set sntp server command
sntp server" on page 14-30).
Whether or not the SNTP server is active.
Enables SNTP in broadcast client mode.
Enables SNTP in unicast (point‐to‐point) client mode. In this mode, the
client must supply the IP address from which to retrieve the current time.
Disables SNTP.
SecureStack C2 Configuration Guide 14-29
set sntp client
("set