Set Newaddrtrap; Show Snmp Notify - Enterasys SecureStack C2 C2G170-24 Configuration Manual

set newaddrtrap

ge.1.1
ge.1.2
ge.1.3
ge.1.4
ge.1.5
set newaddrtrap
Use this command to enable or disable SNMP trap messaging, globally or on one or more ports,
when new source MAC addresses are detected.
Syntax
set newaddrtrap [port-string] {enable | disable}
Parameters
port‐string
enable | disable
Defaults
If port‐string is not specified, the trap function is set globally.
Mode
Switch mode, read‐write.
Usage
This command enables and disables sending SNMP trap messages when a new source MAC
address is detected by a port. If the port is a CDP port, however, traps for new source MAC
addresses will not be sent.
The default mode is disabled globally and per port.
Example=
This example enables the trap function globally and then on Gigabit Ethernet ports 1 through 5 in
slot 1.
C2(rw)->set newaddrtrap enable
C2(rw)->set newaddrtrap ge.1.1-5 enable

show snmp notify

Use this command to display the SNMP notify configuration, which determines the management
targets that will receive SNMP notifications.
Syntax
show snmp notify [notify] [volatile | nonvolatile | read-only]
8-30 SNMP Configuration
disabled
disabled
disabled
disabled
disabled
(Optional) Enable or disable the new MAC addresses trap function on
specific ports.
Enable or disable the new MAC addresses trap function. If entered
without the port‐string parameter, enables or disables the function
globally. When entered with the port‐string parameter, enables or
disables the function on specific ports.