Set Dhcp Pool Client-Name; Clear Dhcp Pool Client-Name - Enterasys SecureStack C2 C2G170-24 Configuration Manual

set dhcp pool client-name

Use this command to assign a name to a DHCP client when creating an address pool for manual
binding.
Syntax
set dhcp pool poolname client-name name
Parameters
poolname
name
Defaults
None.
Mode
Switch command, read‐write.
Example
This example configures the client name "appsvr1" to the manual binding pool "manual2."
C2(rw)->set dhcp pool manual2 client-identifier 01:22:33:44:55:66
C2(rw)->set dhcp pool manual2 host 10.12.1.10 255.255.255.0
C2(rw)->set dhcp pool manual2 client-name appsvr1

clear dhcp pool client-name

Use this command to delete a DHCP client name from an address pool for manual binding.
Syntax
clear dhcp pool poolname client-name
Parameters
poolname
Defaults
None.
Mode
Switch command, read‐write.
Example
This example deletes the client name from the manual binding pool "manual2."
C2(rw)->clear dhcp pool manual2 client-name
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
Specifies the name to be assigned to this client. Client names may be up to
31 characters in length.
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
set dhcp pool client-name
SecureStack C2 Configuration Guide 16-19