Clear Snmp Access - Enterasys SecureStack C2 C2G170-24 Configuration Manual

clear snmp access

Defaults
If security level is not specified, no authentication will be applied.
If context is not specified, access will be enabled for the default context. If context is specified
without a context match, exact match will be applied.
If read view is not specified none will be applied.
If write view is not specified, none will be applied.
If notify view is not specified, none will be applied.
If storage type is not specified, entries will be stored as permanent and will be held through device
reboot.
Mode
Switch command, read‐write.
Example
This example permits the "powergroup" to manage all MIBs via SNMPv3:
C2(su)->set snmp access powergroup security-model usm
clear snmp access
Use this command to clear the SNMP access entry of a specific group, including its set SNMP
security‐model, and level of security.
Syntax
clear snmp access groupname security-model {v1 | v2c | usm} [noauthentication |
authentication | privacy] [context context]
Parameters
groupname
security‐model v1 |
v2c | usm
noauthentication |
authentication |
privacy
context context
Defaults
If security level is not specified, all levels will be cleared.
If context is not specified, none will be applied.
Mode
Switch command, read‐write.
8-18 SNMP Configuration
Specifies the name of the SNMP group for which to clear access.
Specifies the security model to be cleared for the SNMP access group.
(Optional) Clears a specific security level for the SNMP access group.
(Optional) Clears a specific context for the SNMP access group. Enter / ‐ /
to clear the default context.