Set Pwa Ipaddress; Set Pwa Protocol - Enterasys SecureStack C2 C2G170-24 Configuration Manual

set pwa ipaddress

set pwa ipaddress
Use this command to set the PWA IP address. This is the IP address of the end station from which
PWA will prevent network access until the user is authenticated.
Syntax
set pwa ipaddress ip-address
Parameters
ip‐address
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set a PWA IP address of 1.2.3.4:
C2(su)->set pwa ipaddress 1.2.3.4

set pwa protocol

Use this command to set the port web authentication protocol.
Syntax
set pwa protocol {chap | pap}
Parameters
chap | pap
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set a the PWA protocol to CHAP:
C2(su)->set pwa protocol chap
23-66 Authentication and Authorization Configuration
Specifies a globally unique IP address. This same value must be
configured into every authenticating switch in the domain.
Sets the PWA protocol to:
• CHAP (PPP Challenge Handshake Protocol) ‐ encrypts the username
and password between the end‐station and the switch port.
• PAP (Password Authentication Protocol‐ does not provide any
encryption between the end‐station the switch port.