Ip Igmp Startup-Query-Count; Ip Igmp Last-Member-Query-Interval - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Example
This example shows how to set the IGMP startup query interval to 100 seconds on VLAN 1:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip igmp startup-query-interval 100

ip igmp startup-query-count

Use this command to set the number of IGMP queries sent out on startup, separated by the
startup‐query‐interval as described in ip igmp startup‐query‐interval (page 13‐14). The no form of
this command resets the IGMP startup query count to the default value of 2.
Syntax
ip igmp startup-query-count count
no ip igmp startup-query-count
Parameters
count
Defaults
None.
Mode
Interface configuration: C2
Example
This example shows how to set the IGMP startup query count to 10 onVLAN 1:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip igmp startup-query-count 10

ip igmp last-member-query-interval

Use this command to set the maximum response time being inserted into group‐specific queries
sent in response to leave group messages. The no form of this command resets the IGMP last
member query interval to the default value of 1 second.
Syntax
ip igmp last-member-query-interval time
no ip igmp last-member-query-interval
Parameters
time
Defaults
None.
Specifies the number of IGMP startup queries. Valid values are from 1 to
20. The default value is 2.
(su)‐>router(Config‐if(Vlan 1))#
Specifies the IGMP last member query interval. Valid values are from 0 to
255 seconds. The default value is 1 second.
ip igmp startup-query-count
SecureStack C2 Configuration Guide 13-15