Show Cdp; Show Cdp Output Details - Enterasys SecureStack C2 C2G170-24 Configuration Manual

show cdp

show cdp
Use this command to display the status of the CDP discovery protocol and message interval on
one or more ports.
Syntax
show cdp [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, all CDP information will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display CDP information for ports ge.1.1 through ge.1.9:
C2(su)->show cdp
CDP Global Status
CDP Version Supported
CDP Hold Time
CDP Authentication Code
CDP Transmit Frequency
Port
-----------------
ge.
1.1
ge.
1.2
ge.
1.3
ge.
1.4
ge.
1.5
ge.
1.6
ge.
1.7
ge.
1.8
ge.
1.9
Table 6‐1 provides an explanation of the command output.
Table 6-1 show cdp Output Details
Output Field
CDP Global Status
CDP Versions
Supported
CDP Hold Time
6-2 Discovery Protocol Configuration
(Optional) Displays CDP status for a specific port. For a detailed description
of possible port‐string values, refer to
page 7‐2.
ge.
1.1-9
:auto-enable
:30 hex
:180
:00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 hex
:60
Status
auto-enable
auto-enable
auto-enable
auto-enable
auto-enable
auto-enable
auto-enable
auto-enable
auto-enable
What It Displays...
Whether CDP is globally auto-enabled, enabled or disabled. The default state of
auto-enabled can be reset with the set cdp state command. For details, refer to
cdp state" on page 6-3.
CDP version number(s) supported by the switch.
Minimum time interval (in seconds) at which CDP configuration messages can be
set. The default of 180 seconds can be reset with the set cdp hold-time command.
For details, refer to
"Port String Syntax Used in the CLI
"set cdp hold-time" on page 6-5.
" on
"set