Set Dhcp Pool Default-Router; Clear Dhcp Pool Default-Router - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Mode
Switch command, read‐write.
Example
This example restores the default lease duration of one day for address pool "auto1."
C2(rw)->clear dhcp pool auto1 lease

set dhcp pool default-router

Use this command to specify a default router list for the DHCP clients served by the address pool
being configured. Up to 8 default routers can be configured.
Syntax
set dhcp pool poolname default-router address [address2 ... address8]
Parameters
poolname
address
address2 ... address8
Defaults
None.
Mode
Switch command, read‐write.
Example
This example assigns a default router at 10.10.10.1 to the address pool named "auto1."
C2(rw)->set dhcp pool auto1 default-router 10.10.10.1

clear dhcp pool default-router

Use this command to delete the default routers configured for this address pool.
Syntax
clear dhcp pool poolname default-router
Parameters
poolname
Defaults
None.
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
Specifies the IP address of a default router.
(Optional) Specifies, in order of preference, up to 7 additional default
router addresses.
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
set dhcp pool default-router
SecureStack C2 Configuration Guide 16-23