Set Dhcp Bootp - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Stackable switches
Hide thumbs Also See for SecureStack C2 C2G170-24:
Table of Contents

Advertisement

set dhcp
For information about...
clear dhcp conflict
set dhcp exclude
clear dhcp exclude
set dhcp ping
clear dhcp ping
show dhcp binding
clear dhcp binding
show dhcp server statistics
clear dhcp server statistics
set dhcp
Use this command to enable or disable the DHCP server functionality on the SecureStack C2.
Syntax
set dhcp {enable | disable}
Parameters
enable | disable
Defaults
None.
Mode
Switch command, read‐write.
Example
This example enables DHCP server functionality.
C2(rw)->set dhcp enable

set dhcp bootp

Use this command to enable or disable automatic address allocation for BOOTP clients. By 
default, address allocation for BOOTP clients is disabled. Refer to RFC 1534, "Interoperation 
Between DHCP and BOOTP," for more information.
Syntax
set dhcp bootp {enable | disable}
Parameters
enable | disable
16-4 DHCP Server Configuration
Enables or disables DHCP server functionality. By default, DHCP server is 
disabled.
Enables or disables address allocation for BOOTP clients.
Refer to page...
16-6
16-7
16-7
16-8
16-8
16-9
16-9
16-10
16-10

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SecureStack C2 C2G170-24 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

C2h124-24Securestack c2

Table of Contents