Table of Contents
Advertisement
Connecting Using Telnet
Once the SecureStack C2 device has a valid IP address, you can establish a Telnet session from any
TCP/IP based node on the network. For information about setting the switch's IP address, refer to
"set ip address" on page 3‐11.
To establish a Telnet session:
1.
Telnet to the switch's IP address.
2.
Enter login (user name) and password information in one of the following ways:
–
If the switch's default login and password settings have not been changed, follow the
steps listed in "Using a Default User Account" on page 1‐7, or
–
Enter an administratively‐configured user name and password.
The notice of authorization and the prompt displays as shown in Figure
For information about configuring Telnet settings, refer to "Starting and Configuring Telnet" on
page 3‐35.
Refer to the instructions included with the Telnet application for information about establishing a
Telnet session.
Logging In
By default, the SecureStack C2 switch is configured with three user login accounts—ro for
Read‐Only access, rw for Read‐Write access, and admin for super‐user access to all modifiable
parameters. The default password is set to a blank string. For information on changing these
default settings, refer to "Setting User Accounts and Passwords" on page 3‐2.
Using a Default User Account
If this is the first time you are logging in to the SecureStack C2 switch, or if the default user
accounts have not been administratively changed, proceed as follows:
1.
At the login prompt, enter one of the following default user names:
–
ro for Read‐Only access.
–
rw for Read‐Write access.
–
admin for Super User access.
2.
Press ENTER. The Password prompt displays.
3.
Leave this string blank and press ENTER. The switch information and prompt displays as
shown in Figure
Using an Administratively Configured User Account
If the switch's default user account settings have been changed, proceed as follows:
1.
At the login prompt, enter your administratively‐assigned user name and press ENTER.
2.
At the Password prompt, enter your password and press ENTER.
The notice of authorization and the prompt displays as shown in Figure
Note: Users with Read-Write (rw) and Read-Only access can use the
(page 3-5) to change their own passwords. Administrators with Super User (su) access can use
the
password
1‐1.
set system login
command (page 3-4) to create and change user accounts, and the
command to change any local account password.
Using the Command Line Interface
1‐1.
1‐1.
set password
command
SecureStack C2 Configuration Guide 1-7
set
Advertisement
Table of Contents
