Show Eapol - Enterasys SecureStack C2 C2G170-24 Configuration Manual

This example shows how to reset the 802.1X quiet period to 60 seconds on ports fe.1.1‐3:
C2(su)->clear dot1x auth-config quietperiod

show eapol

Use this command to display EAPOL status or settings for one or more ports.
Syntax
show eapol [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, only EAPOL enable status will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display EAPOL status for ports fe.1.1‐3:
C2(su)->show eapol
EAPOL is disabled.
Port
--------
fe
.1.1
fe
.1.2
fe
.1.3
Table 23‐2 provides an explanation of the command output. For details on using the set eapol
command to enable the protocol and assign an authentication mode, refer to "set eapol" on
page 23‐19.
(Optional) Displays EAPOL status for specific port(s). For a detailed
description of possible port‐string values, refer to "Port String Syntax Used
in the CLI" on page 7‐2.
fe
.1.1-3
Authentication State
--------------------
Initialize
Initialize
Initialize
fe
.1.1-3
Authentication Mode
--------------------
Auto
Auto
Auto
SecureStack C2 Configuration Guide 23-17
show eapol