Using The Command Line Interface; Starting A Cli Session; Connecting Using The Console Port; Securestack C2 Startup Screen - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Using the Command Line Interface

Table 1-2 Default Settings for Router Operation (Continued)
Output...
Split horizon
Stub area (OSPF)
Telnet
Telnet port (IP)
Timers (OSPF)
Transmit delay (OSPF)
VRRP
Using the Command Line Interface

Starting a CLI Session

Connecting Using the Console Port

Connect a terminal to the local console port as described in your SecureStack C2 Installation Guide.
The startup screen, Figure
Interface (CLI) by
• using a default user account, as described in "Using a Default User Account" on page 1‐7, or
• using an administratively‐assigned user account as described in "Using an Administratively
Configured User Account" on page 1‐7.
Figure 1-1
Username:admin
Password:
Enterasys SecureStack C2
Command Line Interface
Enterasys Networks, Inc.
50 Minuteman Rd.
Andover, MA 01810-1008 U.S.A.
Phone: +1 978 684 1000
E-mail: support@enterasys.com
WWW: http://www.enterasys.com
(c) Copyright Enterasys Networks, Inc. 2008
Chassis Serial Number:
Chassis Firmware Revision:
C2(su)->
1-6 Introduction
1‐1, will display on the terminal. You can now start the Command Line

SecureStack C2 Startup Screen

041800249041
5.02.xx.xxxx
What it displays...
Enabled for RIP packets without poison reverse.
None configured.
Enabled.
Set to port number 23.
SPF delay set to 5 seconds. SPF holdtime set to 10 seconds.
Set to 1 second.
Disabled.