Clear Cos Port-Resource Flood-Ctrl; Set Cos Reference - Enterasys SecureStack C2 C2G170-24 Configuration Manual

clear cos port-resource flood-ctrl

Use this command to clear flood control port resources to default values.
Syntax
clear cos port-resource flood-ctrl {all | group-type-index {unicast | multicast |
broadcast | all [rate]}}
Parameters
all
group‐type‐index
unicast
multicast
broadcast
all
rate
Defaults
None.
Mode
Switch command, read‐write.
Example
This example clears the unicast port resource for port group 1.0 to default values.
C2(su)->clear cos port-resource flood-ctrl 1.0 unicast

set cos reference

Use this command to set the Class of Service inbound rate limiting reference configuration.
Syntax
set cos reference irl group-type-index reference rate-limit irl-index
Clear all flood control resources for all port groups.
Specifies a port group/type index. Valid entries are in the form of
group#.port‐type.
Valid values for group# can range from 0 to 7. Valid values for port‐type
can range from 0 to 1, although only port type 0 is currently supported.
For example, port group 3 would be specified as 3.0.
Clear unicast port resources for the specified port group.
Clear multicast port resources for the specified port group.
Clear broadcast port resources for the specified port group.
Clear all flood control port resources for the specified port group.
(Optional) Clear the data rate limiter of the specified type of port
resource to the default (none or disabled).
clear cos port-resource flood-ctrl
SecureStack C2 Configuration Guide 11-31