Show Rmon Alarm; Alarm Group Commands - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Alarm Group Commands

Purpose
To display, configure, and clear RMON alarm entries and properties.
Commands
For information about...

show rmon alarm

set rmon alarm properties
set rmon alarm status
clear rmon alarm
show rmon alarm
Use this command to display RMON alarm entries. The RMON alarm group periodically takes
statistical samples from RMON variables and compares them with previously configured
thresholds. If the monitored variable crosses a threshold an RMON event is generated.
Syntax
show rmon alarm [index]
Parameters
index
Defaults
If index is not specified, information about all RMON alarm entries will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display RMON alarm entry 3:
C2(rw)->show rmon alarm 3
Index 3
---------------------
Owner
Status
Variable
Sample Type
Interval
Rising Threshold
Rising Event Index
Table 15‐2 provides an explanation of the command output.
(Optional) Displays RMON alarm entries for a specific entry index ID.
= Manager
= valid
= 1.3.6.1.4.1.5624.1.2.29.1.2.1.0
= delta
= 30
= 1
= 2
Startup Alarm
Value
Falling Threshold
Falling Event Index = 0
SecureStack C2 Configuration Guide 15-9
Alarm Group Commands
Refer to page...
15-9
15-10
15-11
15-12
= rising
= 0
= 0