Reviewing Port Status; Purpose; Commands; Show Port - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Where port number depends on the device. The highest valid port number is dependent on the
number of ports in the device and the port type.
Port Slot/Unit Parameters Used in the CLI
The "unit" parameter is often used interchangeably with "module" in the standalone switch CLI
to indicate a module slot location.
Examples
This example shows the port‐string syntax for specifying the 1‐Gigabit Ethernet port 14 in slot unit
.
3
ge.3.14
This example shows the port‐string syntax for specifying all 1‐Gigabit Ethernet ports in slot unit 3
in the system.
ge.3.*
This example shows the port‐string syntax for specifying all ports (of any interface type) in the
system.
*.*.*

Reviewing Port Status

Purpose

To display operating status, duplex mode, speed, port type, and statistical information about
traffic received and transmitted through one or all switch ports on the device.

Commands

For information about...

show port

show port status
show port counters
show port
Use this command to display whether or not one or more ports are enabled for switching.
Syntax
show port [port-string]
Note: You can use a wildcard (*) to indicate all of an item. For example, fe.3.* would represent all
100Mbps Ethernet (fe) ports in slot 3, and ge.3 * would represent all 1-Gigabit Ethernet (ge) ports
in slot 3.
Reviewing Port Status
Refer to page...
7-3
7-4
7-5
SecureStack C2 Configuration Guide 7-3