Clear Arpinspection Filter - Enterasys SecureStack C2 C2G170-24 Configuration Manual

clear arpinspection filter

Use this command to remove an ARP ACL from a VLAN or from the switch, or to remove a
permit rule from an existing ACL, or to change the status of static mapping to disabled.
Syntax
clear arpinspection filter name [permit ip host sender-ipaddr mac host
sender-macaddr] | [vlan vlan-range [static]
Parameters
name
permit
ip host sender‐ipaddr
mac host
sender‐macaddr
vlan vlan‐range
static
Defaults
If only the name is specified, the ACL is deleted from the switch.
Mode
Switch command, read‐write.
Usage
You can use this command to:
• Remove a configured ARP ACL from the switch, or
• Remove a permit rule from a configured ARP ACL, or
• Remove the association of an ARP ACL with a VLAN or VLANs, or
• Disable static mapping of an ARP ACL associated with a VLAN or VLANs.
Use the set arpinspection filter command to create and assign an ARP ACL.
Use the show arpinspection access‐list command to display currently configured ARP ACLs.
Examples
This example removes a permit rule from the ARP ACL named staticARP.
C2(su)->clear arpinspection filter staticARP permit ip host 192.168.1.10 mac host
00:01:22:33:44:55
This example disables static mapping of the ARP ACL named staticARP that is associated with
VLAN 5.
C2(su)->clear arpinspection filter staticARP vlan 5 static
Specifies the name of the ARP ACL.
(Optional) Specifies that a permit rule is being deleted.
Specifies the IP address in the rule being deleted.
Specifies the MAC address in the rule being deleted.
(Optional) Specifies the VLAN or VLANs to which this command
should apply. Remove the ACL from the VLAN, if static is not specified
also.
(Optional) Specifies that static mapping should be disabled for this ARP
ACL for the specified VLAN or VLANs.
clear arpinspection filter
SecureStack C2 Configuration Guide 17-29