Resetting The Switch; Purpose; Commands; Reset - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Resetting the Switch

Mode
Switch command, read‐only.
Usage
By default, switch timeout occurs after 15 minutes of user inactivity, automatically closing your
CLI session. Use the set logout command (page 3‐29) to change this default.
Example
This example shows how to exit a CLI session:
C2(su)->exit
Resetting the Switch

Purpose

To reset one or more switches, and to clear the user‐defined configuration parameters.

Commands

For information about...

reset

clear config
reset
Use this command to reset the switch without losing any user‐defined configuration settings.
Syntax
reset [unit]
Parameters
unit
Defaults
If no unit ID is specified, the entire system will be reset.
Mode
Switch command, read‐write.
Usage
A SecureStack C2 switch can also be reset with the RESET button located on its front panel. For
information on how to do this, refer to the SecureStack C2 Installation Guide shipped with your
switch.
3-48 Basic Configuration
(Optional) Specifies a unit to be reset.
Refer to page...
3-48
3-49