Show Ip Igmp Groups; Ip Igmp Query-Interval - Enterasys SecureStack C2 C2G170-24 Configuration Manual

show ip igmp groups

Use this command to display a list of IGMP streams and client connection ports.
Syntax
show ip igmp groups
Parameters
None.
Defaults
None.
Mode
Any router mode.
Example
This example shows how to display information about IGMP groups:
C2(su)->router#show ip igmp groups
REGISTERED MULTICAST GROUP DETAILS
Multicast
IP Address
--------------- --------------- ------- ------------ ------------
228.1.1.1

ip igmp query-interval

Use this command to set the IGMP query interval on a routing interface. The no form of this
command resets the IGMP query interval to the default value of 125 seconds.
Syntax
ip igmp query-interval time
no ip igmp query-interval
Parameters
time
Defaults
None.
Mode
Interface configuration: C2(su)‐>router(Config‐if(Vlan 1))#
Example
This example shows how to set the IGMP query interval to 1800 seconds on VLAN 1:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip igmp query-interval 1800
Last Reporter Up Time Expiry Time
12.12.12.2 27
Specifies the IGMP query interval. Valid values are from 1 to 3600
seconds. Default is 125 seconds.
show ip igmp groups
Version1
Host Timer
----------
SecureStack C2 Configuration Guide 13-13