Set Spantree Spanguardtrapenable; Clear Spantree Spanguardtrapenable - Enterasys SecureStack C2 C2G170-24 Configuration Manual

set spantree spanguardtrapenable

set spantree spanguardtrapenable
Use this command to enable or disable the sending of an SNMP trap message when SpanGuard
has locked a port.
Syntax
set spantree spanguardtrapenable {disable | enable}
Parameters
disable | enable
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to disable the SpanGuard trap function:
C2(su)->set spantree spanguardtrapenable disable

clear spantree spanguardtrapenable

Use this command to reset the Spanning Tree SpanGuard trap function back to the default state of
enabled.
Syntax
clear spantree spanguardtrapenable
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset the SpanGuard trap function to enabled:
C2(rw)->clear spantree spanguardtrapenable
9-30 Spanning Tree Configuration
Disables or enables sending SpanGuard traps. By default, sending traps
is enabled.