Table of Contents
Advertisement
Configuring Cisco Discovery Protocol
Purpose
To review and configure the Cisco discovery protocol. Discovery protocols are used to discover
network topology. When enabled, they allow Cisco devices to send periodic PDUs about
themselves to neighboring devices. Specifically, this feature enables recognizing PDUs from Cisco
phones. A table of information about detected phones is kept by the switch and can be queried by
the network administrator.
Commands
The commands used to review and configure the Cisco discovery protocol are listed below. Refer
also to "show neighbors" on page 6‐6.
For information about...
show ciscodp
show ciscodp port info
set ciscodp status
set ciscodp timer
set ciscodp holdtime
set ciscodp port
clear ciscodp
show ciscodp
Use this command to display global Cisco discovery protocol information.
Syntax
show ciscodp
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display global Cisco DP information.
C2(su)->show ciscodp
CiscoDP :Enabled
Timer :5
Holdtime (TTl): 180
Configuring Cisco Discovery Protocol
Refer to page...
6-7
6-8
6-9
6-9
6-10
6-10
6-12
SecureStack C2 Configuration Guide 6-7
Advertisement
Table of Contents
Need help?
Do you have a question about the SecureStack C2 C2G170-24 and is the answer not in the manual?