Using and Configuring WebView
Example
This example shows how to clear configuration parameters (including stacking parameters, if
applicable):
C2(su)->clear config all
Using and Configuring WebView
Purpose
By default, WebView (The Enterasys Networks embedded web server for switch configuration
and management tasks) is enabled on TCP port number 80 on the SecureStack C2 switch. You can
verify WebView status, and enable or disable WebView using the commands described in this
section. WebView can also be securely used over SSL port 443, if SSL is enabled on the switch. By
default, SSL is disabled.
To use WebView, type the IP address of the switch in your browser. To use WebView over SSL,
type in https:// then the IP address of the switch. For example, https://172.16.2.10.
Commands
For information about...
show webview
set webview
show ssl
set ssl
show webview
Use this command to display WebView status.
Syntax
show webview
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
3-50 Basic Configuration
Refer to page...
3-50
3-51
3-51
3-52