Table of Contents
Advertisement
show dhcpsnooping binding
Defaults
None.
Mode
Switch command, read‐write.
Usage
This command displays the trust state and rate limiting parameters configured on the specified
ports.
Example
This example shows the output of the show dhcpsnooping port command.
C2(su)->show dhcpsnooping port ge.1.1
Interface
----------
ge.1.1
show dhcpsnooping binding
Use this command to display the contents of the DHCP snooping bindings database.
Syntax
show dhcpsnooping binding [dynamic | static] [port port-string] [vlan vlan-id]
Parameters
dynamic | static
port port‐string
vlan vlan‐id
Defaults
If no parameters are entered, all bindings in the database are displayed.
Mode
Switch command, read‐write.
Usage
This command displays information about the DHCP bindings in the DHCP snooping database.
Example
This example shows the output of the show dhcpsnooping binding command when no
parameters are entered.
C2(su)->show dhcpsnooping binding
Total number of bindings:
17-12 DHCP Snooping and Dynamic ARP Inspection
Trust State
Rate Limit
-------------
-------------
No
(Optional) Limits the display of bindings in the database by type of
entry, either dynamic or static.
(Optional) Limits the display of bindings in the database by port.
(Optional) Limits the display of bindings in the database by VLAN id.
2
Burst Interval
(pps)
(seconds)
---------------
20
2
Advertisement
Table of Contents
