Clear Dhcp Pool; Set Dhcp Pool Network - Enterasys SecureStack C2 C2G170-24 Configuration Manual

clear dhcp pool

clear dhcp pool
Use this command to delete a DHCP server pool of addresses.
Syntax
clear dhcp pool poolname
Parameters
poolname
Defaults
None.
Mode
Switch command, read‐write.
Example
This example deletes the address pool named "auto1."
C2(rw)->clear dhcp pool auto1

set dhcp pool network

Use this command to configure the subnet number and mask for an automatic DHCP address
pool.
Syntax
set dhcp pool poolname network number {mask | prefix-length}
Parameters
poolname
number
mask
prefix‐length
Defaults
None.
Mode
Switch command, read‐write.
Usage
Use this command to configure a set of IP addresses to be assigned by the DHCP server using the
specified address pool. In order to limit the scope of the addresses configured with this command,
use the set dhcp exclude command on page 16‐7.
16-14 DHCP Server Configuration
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
Specifies an IP subnet for the address pool.
Specifies the subnet mask in dotted quad notation.
Specifies the subnet mask as an integer.